Cateye CC-HB1OO User Manual download pdf (Page 9)

Mounting Main Unit

Slide the main unit onto the bracket from front until it clicks into position. The contacts will

automatically connect. To remove the unit, pull it off forward while pushing down the lever

(Fig. 15).

Test

Mount the main unit. Spin the wheel to check if the sensor pulse symbol ( ) flashes. If not,

adjust the relative positions of the magnet and sensor following the instructions.

This completes the mounting process.

3. Auto (Automatic Start/Stop) Function

This function enables the main unit to start or stop automatically without operation of the right

button, in which

symbol appears on the screen (Fig. 16).

How to Switch on/off Auto Function

When the Set button is pressed in T, D or A mode, symbol appears and Auto function is

on. To clear this function off, press SET button again and

symbol disappears.

• In this function, it starts/stops by perceiving revolutions of the wheel, so it stops measuring

the elapsed time when the wheel ceases moving.

• While this function is on, 2 seconds may be elapsed at the moment when the main unit is

mounted onto the bracket.

• When using this unit as an independent heart rate monitor apart from bicycle, switch off

this function. Operation of the right (Start/Stop) button is needed.

4. Power Saving Function

When the main unit is left without receiving any signal for about 60 minutes continuously,

power supply is shut down and the unit will be in "sleep" state displaying only

display

(Fig. 17).

By receiving signal from the wheel, or by a press of the right or left button, the unit "wakes

up".

Fig.17

Fig.16

Fig.15

Lever

Slide

Front

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

No comments

Cateye CC-HB1OO User Manual Page 9