Cateye EC-2300R Service Manual download pdf (Page 27)

Cateye Ergociser Series 1000 Service Manual

EC-1200 EC-1600 EC-3600 EC-3700

Applicable Models:

ES-2

Fig. 1

EC-1200

Fig. 2

Fig. 3

EC-1200

Fig. 4

EC-1600

Fig. 5

Fig. 6

Fig. 7

Screws

Replacing the 5P Cable (1)

Procedures are different depending on the type of model as shown

below:

àUpright Type (EC-1200)

T Removing the Existing Cable

1. Loosen the four screws which fix the control unit to remove the

control unit. Also, remove the cable connector. (Fig. 1)

2. Remove the cable holder which fixes the 5P cable to the

handlebar post.

3. Remove the frame cover. (See the Section D-1 "Removing the

Frame Covers.")

4. Remove the CN-2 connector from the power supply board.

(Fig. 2)

5. Cut the cable holders which fix the 5P cable to the frame, and

remove the 5P cable.

T Mounting the Brand New Cable

1. Mark the 5P cable at a point approx. 87cm from the unit-side

cable connector (Fig. 3), and connect the leading end of the

CN-2 connector to the power supply board.

2. (1)Using cable holders, fix the 5P cable at the bottom of the

handlaber pipe of the main unit frame.(2)Fix the cable at the

marked point of the cable to the handlebar pipe just beneath

the horizontal frame.(3)Pass the 5P cable along with the

handlebar pipe, and the sagging portion should be binded with

a cable holder. (Fig. 4)

3. Connect the cable connector to the control unit, and apply the

connector cover.Then, fix the control unit to the handlebar post

by using four screws. (Fig. 1)

4. Provisionally turn on the power, and check if the control unit

works fine.

5. Fix the 5P connector to the handlebar post with the cable

holder.

6. Mount the frame cover. (See the Section D-1 "Removing the

Frame Covers.")

àUpright Type (EC-1600)

T Removing the Existing Cable

5P Cable Handleber Post

1. Loosen the four screws which fix the control unit to remove the

control unit. Also, remove the cable connector. (Fig. 4) Slide

the inner handlebar post cover upward, and unplug the cable

connector. (Fig. 5)

2. Remove the screws of both the handlebar stem and the outer

handlebar post cover to remove the 5P cable. (Fig. 6)

5P Cable within the Frame

1. Remove the frame cover. (See the Section D-1 "Removing the

Frame Covers.")

2. Remove the CN-2 connector at the end of the 5P cable from

the power supply board.

3. Cut the cable holders which fix the 5P cable to the handlebar

pipe, and remove the 5P cable.

To be continued on the next page.

Fig. 8

Cable

Connector

Power Supply Board

Unit-Side Cable Connector

Mark this point.

87cm

Handlebar Pipe

Horizontal Frame

Cable Holders

(1)

(2)

(3)

Cable

Connector

Screws

Unplug

Inner Handlebar Post Cover

Screws

Handlebar Stem

Cover

Cable Connector

Cable Holder

5cm

Replacing the 5P Cable (1)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 70 71

Comments to this Manuals

No comments

Cateye EC-2300R Service Manual Page 27

Comments to this Manuals

Related products and manuals for Bicycles Cateye EC-2300R