Cateye CC-RD420DW Instruction Manual download pdf (Page 2)

CC-RD420DW ENG

How to install the unit on your bicycle

3 mm

When attaching the FlexTight™ bracket to the stem :

Attach the bracket to the stem or handlebar

The FlexTight™ bracket can be attached to either the stem or the handlebar, depending on how the bracket ﬁts into the bracket band.

Caution: Be sure to tighten the dial of the FlexTight™ bracket by hand.

Tightening it strongly using a tool, etc. may damage the screw thread.

Install the speed sensor to the front fork or

chain stay

* The speed sensor can be used either installed to the front fork

or chain stay.

Remove/Install

the computer

Bracket

band

Speed sensor

(SPD-10)

Sensor rubber

pad

Nylon ties

(x 2)

Magnet

Bracket band

Handlebar

Click

Dial

Cut

While supporting it by hand,

Push it out as if lifting

the front up

Stem

Bracket

Dial

Bracket rubber

pad

Bracket rubber pad

Sensor

rubber pad

Speed

sensor

Nylon ties

Pull

securely

Magnet

Spoke

Magnet

SENSOR ZONE

Speed sensor

Magnet

Speed

sensor

SENSOR ZONE

To the SENSOR ZONE

When attaching the FlexTight™ bracket to the handlebar :

When installing to

the front fork:

When installing to

the chain stay:

Install the sensor and

magnet

The magnet

passes through

the sensor

zone.

The clearance

between the sen-

sor and magnet is

3 mm or less.

Caution:

Round off the cut

edge of the bracket

band to prevent

injury.

* To mount the bracket to an aero-shaped handlebar or larger stem, use the optional nylon ties

bracket.

* The magnet may be installed any-

where on the spoke if the above

installation conditions are satisﬁed.

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Cateye CC-RD420DW Instruction Manual Page 2

Comments to this Manuals

Related products and manuals for Bicycle accessories Cateye CC-RD420DW