Cateye CC-AT100 Instruction Manual download pdf (Page 12)

• Secure the wire with the wire securing tape as in Fig. 20. Wind

the wire round the outer cable up to the handlebar. When ad-

justing the length, be careful that the wire will not hinder handle-

bar operation.

• By using the rubber pad, attach the bracket close to the handle-

bar stem (Fig. 21).

2. Auto (Automatic Start/Stop) Function

This function enables the unit to start/stop automatically without operation of the S/S button. In this function,

sym-

bol appears on the screen (Fig. 23). It starts measuring automatically even when the power-saving function is on.

• In this function, it starts/stops by perceiving revolutions of the wheel, so it stops measuring when the wheel ceases

moving.

• While this function is on, 2 seconds may be elapsed at the moment when the main unit is mounted onto the bracket.

• When using this unit on its own apart from bicycle, switch off this function. Operation of the S/S button is needed.

How to Switch on/off Auto Function

Operate the mode button to display the main mode showing T, D or A. Get the stop state by pressing the Set button;

then

symbol appears and the Auto function is on. To switch this function off, press the Set button again and

symbol disappears.

Slide

Mounting Main Unit

Slide the main unit onto the bracket from front until it clicks into

position. The contacts will automatically connect. To remove the

unit, pull it off forward while pushing down the lever (Fig. 22).

Test

Mount the main unit. Spin the wheel to check if the display shows

the speed. If not, adjust the relative positions of the magnet and

the sensor again following the instructions.

Rubber Pad

Bracket

Wire

Wire Securing

Tape

Speed Sensor

Bracket

Fig.21

Front

Lever

Fig.22

Fig.23

Fig.20

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Cateye CC-AT100 Instruction Manual Page 12